Qoltec Media конвертор SWITCH Ethernet 1x RJ45 1x SFP

Qoltec Media конвертор SWITCH Ethernet 1x RJ45 1x SFP

Description:

Bet on technology that makes a difference – gigabit speed, maximum throughput, flexible configuration

A reliable and efficient network device that enables conversion of the signal from RJ45 cable (10/100/1000 Mbps) to fiber optic cable and vice versa with a transmission speed of 1000 Mbps. It provides a stable and fast connection and smooth data transmission. The device works bidirectionally – it supports both sending and receiving data In Full-Duplex or Half-Duplex mode. Such functionality allows significantly Expand the capabilities of the network infrastructure, without the need for complex solutions or incurring the cost of investing in additional equipment.

Robust metal construction, advanced features and ease of use

Discover new possibilities with a Qoltec device that offers:

• Supports Simultaneous transmission and reception of data In Full-Duplex or Half-Duplex mode,
• Equipped with 4 RJ45 ports and SFP,
• SFP data rates up to 1Gb/s,
• Metal housing,
• LED indicators for connection status and activity : TX, FX LINK/ACT, POWER, FDX,
• Works with CAT 5, 5e, 6, 7 ,8 network cables,
• Provides high resistance to electromagnetic interference and stable data transmission even over long distances.

Expand your multimedia capabilities in just minutes

Our device Offers instant and hassle-free installation, thanks to Plug & Play technology, which requires no additional configuration or technical expertise. The device is ready to work almost immediately after connecting, just follow a few steps:

• Insert the appropriate SFP module into the slot on the конвертор,
• Connect the devices to the appropriate ports using network cables and fiber optic patchcord,
• Connect RJ45 port to router, switch or access modem,
• Connect the power supply and make sure the LEDs indicate activity on the ports.

How to properly set up a fiber optic connection?

To create a full network connection over fiber, in most cases two media конверторs are needed – one on each side of the link. Such a configuration is required when the two devices you want to connect (e.g. switches, routers, computers) have only standard RJ45 (Ethernet) ports and no integrated SFP ports. However, if one of the devices already has an SFP port and supports fiber optic modules (e.g., a modern switch), you only need to use one конвертор on the device side without an optical port.